The new rice processing equipment has high efficiency, energy saving and price reduction. What is the process flow of small processing equipment? Today, Win Tone will tell you that when the grain enters from the feed hopper, there is a moisture detector in the elevator. If the moisture detector does not meet the requirements, it will enter the upper wringer Long, tempering storehouse, drying storehouse, and then through the hoist. After passing the unloading wheel and lower winch, enter the hoist and test again. If it fails, it will continue to circulate. Otherwise, it will enter the grain discharge tube and pack, and the process is over.
Description of small rice processing equipment:
1. From conventional drying methods, different types of food, rice, are different. The rice is not harvested in time for harvesting, cracking may occur in the wild or exploding waist varieties, there are also many provincial rice chilling damage, broken rice, mixed rice husk, dry wheat beer, need to accelerate drying into a slow, slow or low speed ratio of 3 -4°C controlled temperature. For immature, greener rice grains, stop taking a 5-6% water set point increase for small rice processing plants.
2. Clean and maintain when dry and idle. Timely cleaning, cleaning up the residual grain, closing the import and export, etc., is beneficial to the mechanical life and improving the drying efficiency of the small rice processing equipment.
3. The grain load should meet the requirements, not too much, not too little. Excessive load will cause blockage, and too small load will not only reduce the operating efficiency, but also affect the drying quality. When the full amount is reached, there is still a small amount of rice that cannot be added. Can be reheated within 1 hour after drying. Putting it in within 1 hour will not cause uneven drying of the millet processing equipment.
4. After the rice and wheat with extremely high water content are dried, bridging should be prevented. After sending the window, it should be dried immediately, that is, one side of the feed is dry. In addition, small-scale rice processing equipment has defects such as affected germination rate, easy peeling, long drying time, high cost, and unsatisfactory color after drying.
5. The impurity content of grain should not be too large. Such as wet grain, wheat mixed with a lot of straw, wheat straw and other sundries mixed in, will affect the flow of food, so that part of the food can not get a good circulation, causing uneven drying, fermentation or even; at the same time, it also increases the power consumption, the efficiency of fuel consumption is reduced. Therefore, the drying process of the small rice processing equipment before rough processing is required.
For more knowledge about the grain processing equipment industry, you can pay attention to China Win Tone Machinery.: rice processing equipment, millet processing equipment, corn processing equipment, corn processing machinery, grain processing equipment https://www.wintone-machinery.com/
English
Русский
Français
العربية
Español
